create@beadinspirations.com 
1544 Park Street, Alameda, CA 94501 
510-337-1203 

Free Shipping in the US on orders over $35! 


Amazing Amazonite

Amazing Amazonite Necklace

We offer the ingredients to make this magnificent necklace individually as well as a necklace kit. This necklace is also available already assembled. The inner diameter of this necklace is approximately 18" inches.

Components

  • 1 Amazonite Cabochon
  • 10 Amazonite Chips
  • 5 Swarovski Tahitian 8mm crystal pearls
  • 8 Swarovski Tahitian 6mm crystal pearls
  • 1 Vintaj Princess Cut filigree
  • 1 Vintaj Diamond Swirl Filigree
  • 6 Vintaj JR30 5.25mm jump rings
  • 10 Vintaj nickel-free brass 1.5" eyepins
  • 4 Vintaj nickel-free brass 1" headpin
  • 4 Vintaj nickel-free brass 2" headpin
  • 1 Vintaj Swirl clasp set
  • 11" Vintaj cable chain with flattened loops
  • Vintaj Melon spacer beads
  • Vintaj Beech Leaves
  • Vintaj Arte Metal Tiered Leaves
  • Vintaj Daisy Bead Caps
  • 1 foot 24g Artistic Wire gun metal or Vintaj Bronze wire
Make earrings to match!
Choose one of these designs or design your own!

Techniques Used

Tools Needed

You will assemble the filigree wrapped pendant first, then the various chains and attachments, add the neck chain and clasp component, and finally, add the dangle on the end of the pendant.

  1. Assemble the filigree wrapped pendant:
    • Place the Cabochon in the center of the Diamond Swirl Filigree.
    • Turn in the edges of the Diamond Swirl Filigree around the cabochon with your fingers. It works best to turn one side, then the other, alternately repeating sides.
    • Make sure all sides of the filigree are symmetrical and holding the focal bead securely.
    • To tighten the filigree around the cabochon, you may roll the wrapped filigree on the table.
  2. Secure the filigree wrapped cabochon to the Princess Filigree:
    • Locate holes on the back of your filigree-wrapped bead that appear to have the most space to accommodate a piece of wire.
    • Cut two 6-inch pieces of your 24g Vintaj wire.
    • Thread one piece of the wire through a couple of filigree holes about 1/3 from the top of the bead, so that the two ends of the wire are sticking out the back of the filigree.
    • Thread the other piece of wire about 1/3 from the bottom of the filigree-wrapped bead.
    • Weave each piece of wire through the open (unwrapped) filigree and pull it tight. Weave each wire back through about 3 times, or until secure.
    • Trim any excess wire and tuck in the ends. Look to see if the top of the filigree wrapped bead sags away from the open filigree. If it does, grab onto the wire on the back of the open filigree with your round nose pliers to twist the wire into place, which will tighten the wire, and pull in the filigree-wrapped bead.
  3. With metal hole punch pliers, punch a hole approximately 2mm from the tip of the Arte Metal Tiered Leaves.
  4. Apply gilders paste to the Arte Metal Tiered Leaves and Beech Leaves. Wipe off excess.
  5. Assemble the components as shown in the picture.



All components to make Amazing Amazonite Necklace

All components to make Amazing Amazonite Necklace

This includes all components to make the Amazing...

$59.99

Add:

Amazing Amazonite Necklace - Finished Necklace

Amazing Amazonite Necklace - Finished Necklace

Buy the Amazing Amazonite Necklace already made....

$299.99

Add:

Amazonite Cabochon 28mm

Amazonite Cabochon 28mm

Natural color.  It does not have a hole, but...

$11.99

Add:


Amazonite Chips- 20 pieces

Amazonite Chips- 20 pieces

Natural color

$7.99

Add:

Artistic Wire Antique Brass Color 24g - 10 yd. spool

Artistic Wire Antique Brass Color 24g - 10 yd. spool

10 yd spool. 24 gauge This permanent colored...

$4.75

Add:

Gilders Paste Patina

Gilders Paste Patina

Gilder's Paste is a wax-based medium can be...

$11.17

Add:


Vintaj Arte Metal Tiered Leaves AFS0002

Vintaj Arte Metal Tiered Leaves AFS0002

36x23.5mm. Vintaj nickel-free Arte Metal pendant....

$3.99

Add:

Vintaj Brass 3.5mm x 4mm Cable Chain with Flattened Loops CH40

Vintaj Brass 3.5mm x 4mm Cable Chain with Flattened Loops CH40

Vintaj nickel-free brass chain. Chain is priced...

$0.39

Add:

Vintaj Brass 6mm Daisy Bead Cap BC90

Vintaj Brass 6mm Daisy Bead Cap BC90

Vintaj nickel-free brass 6mm flower bead cap....

$0.37

Add:


Vintaj Brass Beech Leaf FS018

Vintaj Brass Beech Leaf FS018

23x16mm. Vintaj Natural Brass Fastenables....

$0.77

Add:

Vintaj Brass Diamond Swirl Filigree - wrap F370

Vintaj Brass Diamond Swirl Filigree - wrap F370

44x44mm. Vintaj nickel-free brass filigree. Wrap,...

$3.69

Add:

Vintaj Brass Emblazonry DP0027

Vintaj Brass Emblazonry DP0027

Vintaj nickel-free brass drop. 25x16mm.

$1.65

Add:


Vintaj Brass Eye Pin - 1.5" EP15

Vintaj Brass Eye Pin - 1.5" EP15

21 gauge eye pin, 1.5". Vintaj nickel-free...

$0.13

Add:

Vintaj Brass Filigree Bead - Wrap Oval BD50

Vintaj Brass Filigree Bead - Wrap Oval BD50

Vintaj nickel-free natural brass. Measurements:...

$1.23

Add:

Vintaj Brass Head Pin - 1" Nickel-free Brass

Vintaj Brass Head Pin - 1" Nickel-free Brass

21 gauge, 1" Vintaj nickel-free brass Add...

$0.11

Add:


Vintaj Brass Head Pin - 2" HP2

Vintaj Brass Head Pin - 2" HP2

21 gauge Vintaj essential! Add coiled drops,...

$0.15

Add:

Vintaj Brass Jump Ring - 5.25mm JR30

Vintaj Brass Jump Ring - 5.25mm JR30

18 gauge Vintaj nickel-free brass. Price for one...

$0.15

Add:

Vintaj Brass Melon Bead 3mm BD70

Vintaj Brass Melon Bead 3mm BD70

Vintaj nickel-free brass 3mm bead. Great spacer...

$0.19

Add:




Copyright © 2020 Bead Inspirations. Powered by Zen Cart