This includes all components to make the Flourish Blossom Necklace.  Comes unassembled. You will need round nose pliers, chain nose pliers or flat nose pliers, and flush cutters to complete this project, not included.  Instructions are not included in this kit. Download our free technique sheets for tips on how to make a basic link. To assemble this necklace: Stack beads and flourish bead cap on a 2" headpin. (Sequence on headpin from bottom to top: rondell, bellflower, flourish bead cap, foliage bead cap, rondell)  Make a loop at top of the beads. (2 assemblies) Stack bellflower and rondell on a 1" head pin.  Make loop at top.  (2 assemblies) Stack blossom bead caps and rondelles on an eye pin.  Make a loop at the end (4 assemblies). Cut 2 inches of the chain.  Open the loop of the flourish bead cap head pin assembly and hook to the end of the 2" chain and close the loop. Open the loop of the other flourish bead cap head pin assembly and hook to the 4th chain link on the other end.  Close the loop. Use 4.75mm jump rings to attach the filigree leaves and the bellflower rondell assemblies to the 2" of chain.  Attach the 7.25mm jump ring to the end of the chain (that doesn't have the flourish bead cap assembly) to the scrolled filigree ring and the hammered ring.  Close the jump ring. Open the 5.25mm jump ring and attach it to the 7.25mm jump ring and one piece of the long chain that is left.  Close the jump ring. From the long piece of the chain that is attached to the 5.25mm jump ring, count to the 4th link of chain and cut it. Open the loop of one of the blossom bead cap-rondell-eye pin linkages, hook it to the end of the chain that you just cut and close it. Open the other loop of the linkage and hook it to the long piece of chain.  Close the loop around the chain. Re-open the 5.25mm jump ring and attach the end of the long chain.  Close the jump ring. Count to the 4th link of chain on the side of the long chain that does not yet have the blossom bead cap-rondell-eye pin linkages. Cut the 4th link. Open the loop of one of the blossom bead cap-rondell-eye pin linkages, hook it to the end of the chain that you just cut and close it. Repeat steps 12-15 to add the next set of blossom bead cap-rondell-eye pin linkages. Cut the chain in the center of the back. Attach the swirl clasp to the chain in back. The pink bellflower beads that are included are the ones that are shown in the picture below.  (The picture to the above shows bellflower beads that are similar, but no longer available.  We show that picture because it shows the construction from another angle.)